TUTORIAL FOR MAKING FABRIC FLOPS

First, take out the plastic doohickeys that are attached to the flip flops.

Two: To begin, take a strip of fabric that is roughly 10 inches long and 1 inch wide.

Advice: Just cut a small opening of about an inch into your fabric, then pull and tear. Much simpler!

Step three: Fold the strip in half and insert your toes through the bottom of the top center hole, but do not knot it just yet.

Four: Tear a piece of fabric that is about 4 inches wide and about 25 inches long (this will give you lots of extra but that is ok – rather too much than not enough).

Five: Thread one end of the 4-inch strip through one of the bottom holes on the flip flop base and tie a tight not.

Six: Pull the 4-inch strip through the 1-inch strip’s loop.

Seven: And back down to the hole on the other side of the flip flop.

Eight: Fit the flip to your foot by pulling on the straps to where it fits you comfortably and tight enough to stay on.

Nine: Tie the strips of fabrics into knots and trim off the excess fabric.

Ten: Hot glue around the knots to make them just a bit more secure into the holes of the flips flops.

Because there are already holes in the flip-flop bases the knots fit pretty well inside and you can’t feel those knots when you are walking.

My new Fabric Flip Flops are so cute and I can’t wait to hear all of the compliments I’m going to get on them!